Additional commands to manage the probe runs

Enables you to return to the exact same counting sites if the same slide is on the microscope and the contour is lined-up properly on the image to mark more cells.

• If you mark more cells, the results are modified accordingly.
• This does not create a new probe run.

Exception: If you click Stop while revisiting a probe run, a new probe run is generated .

You have 2 options for the newly generated probe run:

• Continue Probe Run: Continue visiting the sites OR
• Mark as Completed: No need to visit the remaining sites.

Available if you stopped a probe run (see above): continue visiting the sites.

Uses the same contour but is performed over different counting sites since the grid is applied randomly.

• Creates a new probe run.
• It is helpful to save your parameters in Step 9: Save Sampling Parameters so that you can verify whether the parameters in use are correct in Step 10 in the Sampling box.

Use to count a different type of particle within the same contour, or to apply different parameters.

Removes the probe and its data from the program.

Redirects you to the previous counting sites while hiding existing markers.

• Creates a new probe run.

Lists the current characteristics of the probe.

Redirects you to the Probe Run List in which the probe run results are available.

Also available at Step 11: Viewing Results.