Section shrinkage is likely to be different along the X, Y and Z axes, particularly along the Z (depth) axis. The standard model for shrinkage assumes that shrinkage is linear. This means that the shrinkage at the top of a section is the same as the shrinkage at the bottom of a section. In fact, it implies that the shrinkage occurs equally all along any axis of the tissue.
Shrinkage correction is easy to apply when shrinkage is linear. The Z axis is multiplied by a factor to adjust the data for shrinkage. Data entered after applying shrinkage correction is not affected.
To adjust the scaling of the X or Y axis, see Adjust Scaling.
Scaling Factors - Example
For simplicity, assume that a section that was cut at 80µm shrinks to a thickness of 50µm. The final tissue is 5/8 the thickness of the original tissue. To apply a correction to restore the tracing to the original size, the data must be multiplied by 8/5.
To apply shrinkage to a single section, click Show current section in the Serial Section Manager window.
To apply shrinkage to all of the data in the file, click Show current section again to disable it.
It is important to determine how much shrinkage each section, or series of sections, has undergone during preparation.
Also see Correcting for an upside-down section while tracing, Flipping a single section with a completed tracing